The marked-up image below assists in identifying the stamp where a particular flaw is located on the printed sheet.
It modifies the details prepared by Mr. Norm Sheppard in 1979.
The diagram is divided into nine sections and the number of the stamp on the sheet (from 1 to 30) with a flaw in a particular location is marked.
The map below shows the location by stamp number of many of the printing flaws on the 1d (1/-) Consumptive Homes stamp.
The number can be used in the table below the map to view the identified flaws on that stampp and on other stamps in that row.
The stamp image with that number can be seen with its flaw(s) from the following:
Note that some flaws might appear on some stamps but not on others. There are two possible reasons for this:
1. the problem identified could be an emerging one and a stamp being analysed came from a plate used later in the printing process.
This could be the case when a plate became worn and the frames cracked.
2. the problem is not really a flaw but a temporary issue with some dirt on the plate during the printing of some sheets.
The problem was then probably removed by the Stamp Printer wiping the plate clean during the printing process.
Some "flaws" also appear when too much ink has been applied by the printer or the plate had been used too long before being reinked.